FAST 90mm Intakes - DISCONTINUED
Motors are just going to get bigger from here into forever as far as performance goes.
03-05-2008, 09:52 AM
#22
Staging Lane
Join Date: Oct 2007
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
I think the two reasons one to charge more and two so you buy there TB. and see that they corrected the throttel sticking problem. also now the other 90s out there are obsolete there getting mad that nick Williams and other are making TB to fit there intake. but why cant you stick a 90 mm on a 92 intake and if so why not have some one make a 95 mm TB or possibility bigger and port the opining out to work on the bigger motors would be a good idea and the smaller motors i bet the 90 mm would work fine.. i haven't got mine yet i ordered the new 92 but if i see they did not correct the map sensor lock tab and did not add one then there kinda stupid in my book ....
03-05-2008, 10:59 AM
#23
They dont have to make them, weve been using 95mm LS tbs for over a year now. Fast just updating their intake a bit to entice a few more customers. Proven product and they are just trying to make some improvements, give you the right hardware (stainless steel) the first time. Dats all guys 
03-05-2008, 02:33 PM
#25
Hahahaha yous guys guys ought to know better by now. We go from a 78 to an 85 to a 100 MAF and TB's are no different. People want the most flow. The more air you need the more the need to remove restrictions. few mm's here and there. The 90 is replaced by the 92, it isnt meant for people with 90's to run out and buy a 92 LMAO!!!
Would be interesting to see if the ported 92 flows more than a ported 90, but purely information interest for me.
Would be interesting to see if the ported 92 flows more than a ported 90, but purely information interest for me.
Last edited by 99blancoSS; 03-05-2008 at 02:49 PM.
03-06-2008, 08:34 AM
#28
Staging Lane
Join Date: Oct 2007
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
They dont have to make them, weve been using 95mm LS tbs for over a year now. Fast just updating their intake a bit to entice a few more customers. Proven product and they are just trying to make some improvements, give you the right hardware (stainless steel) the first time. Dats all guys
03-09-2008, 11:43 PM
#29
TECH Resident
Join Date: Jan 2007
Location: Texas
Posts: 751
Likes: 0
Received 0 Likes
on
0 Posts
03-11-2008, 08:23 PM
#32
Launching!
Did FAST ever fix the throttle sticking problem with their 90mm throttle bodies? One of those pieces of junk is still residing in my storage room after I got tired of trying to get a replacement that didn't stick and switched to a TPIS ...
03-13-2008, 03:03 AM
#33
And on the flipside, can the current 90mm TBs (both factory and aftermarket) be used on the new 92mm FAST intake without extra porting or anything?
Yes, also along the lines of what I'm asking.
Yes, also along the lines of what I'm asking.
