Comp cams Solid roller lifters from a broken engine?
#1
TECH Apprentice
Thread Starter
iTrader: (3)
Join Date: Jan 2006
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Comp cams Solid roller lifters from a broken engine?(PICs)
i just checked my lifters from my old broken engine,, and i found some problem with couple of them...and i'm not sure if i can use them in my new setup,,(got 2 bended valves in i piston),,please say that it's ok,,,
(i have high Res. pic if anyone intrested)
and how can i make sure that the rest are good to use in the new engine?
i'm not sure if this is the right part number for my lifters becouse MTI bought it for me about a year ago.(couldn't find a part# on it)
http://www.compperformancegroupstore...Category_Code=
i need ur help Experts
thx in advance
(i have high Res. pic if anyone intrested)
and how can i make sure that the rest are good to use in the new engine?
i'm not sure if this is the right part number for my lifters becouse MTI bought it for me about a year ago.(couldn't find a part# on it)
http://www.compperformancegroupstore...Category_Code=
i need ur help Experts
thx in advance
Last edited by Houston999; 11-02-2008 at 12:49 PM.
#3
TECH Senior Member
iTrader: (18)
Join Date: Jun 2002
Location: NW Houston, TX
Posts: 10,036
Likes: 0
Received 0 Likes
on
0 Posts
Based on how those pics look I would say no. They also look like the old solid lifter that comp made as I do not see the EDM. You can send them back to comp for inspection if you would like, but I would just buy a new set.
#4
the EDM is placed of the other side of the lifters,but it seems that i have to buy new set if u guys recommned that
thank you
Last edited by TNTaddict; 11-03-2008 at 03:57 AM.
#7
Trending Topics
#8
thx alot,,,i'll buy a new set as you guys recomended,,
i searched about which one to use and found out that most of the folks are using Morel Or Crower, Morel is cheaper but if there are any advantges going with Crower, i'd go for it,i'm using a cam with .780" lift.
i searched about which one to use and found out that most of the folks are using Morel Or Crower, Morel is cheaper but if there are any advantges going with Crower, i'd go for it,i'm using a cam with .780" lift.