Where have all the rods gone?
#21
The pistons I'm using are for a 6.125 rod/3.48 stroke combo. I'm off-set grinding the crank to 3.50 stroke to make up for some of the difference in rod length, then check deck height to see where we're at. If it's not too far down in the hole I'll just cut the deck. If it's in a block that's welded between the cylinders or has five sleeves, who cares? There's lots of parts at the shop that are more or less junk to customers, but that doesn't mean I can't throw something together from the "good" junk. This is for a circle track motor, probably 300-325hp at the most. I definitely wouldn't recommend a customer build an engine like this.