LS7 Solid Roller Build and 200 mph Mazdas
#61
TECH Fanatic
iTrader: (16)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Thanks for the heads up. When I bought them there really wasn't much info floating around on them. I'm starting to see a few reports of that. At least it should show up in lash adjustments.
What's interesting is the T&D's on my dad's big block have pressurized oil feeding the rocker trunion through the pushrod cup. These don't have any oiling ports. I bet if it had better oiling the needle bearings would be fine.
What's interesting is the T&D's on my dad's big block have pressurized oil feeding the rocker trunion through the pushrod cup. These don't have any oiling ports. I bet if it had better oiling the needle bearings would be fine.
#62
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Only took 6 years, but we made some noise yesterday! I'll make a dyno results thread. Don't mind the smoke - leaking valvecover after adjusting the valves.
Here are the dyno results
https://ls1tech.com/forums/dynamomet...l#post20546162
Here are the dyno results
https://ls1tech.com/forums/dynamomet...l#post20546162
Last edited by spanks13; 03-07-2024 at 05:36 PM.
The following 5 users liked this post by spanks13:
Bob570 (03-07-2024), gnx7 (03-11-2024), jayyyw (03-07-2024), NAVYBLUE210 (03-07-2024), Ryans99ls1 (03-08-2024)