I always call..you'll never see me asking something and there's a Manufacturer that has a phone line...
Skip the BS...
There isn't a LS head I haven't called in...
Luv ya

 

The Brodix LS7 heads are badass. Been there... seen that.

 

Yeah there's some special ones.....Wish I could get FED F710 heads as cast....I'm sure Chris would do a small port for me LOL.

 

Thats why for a mere 800$, im considering pickn up a set for a future build perhaps...

 

Pretty sure Tony got better results with the TFS castings.

 

That's what I heard too.
410cfm peak flow at .700 lift through a 260 or 265CC runner if my memory serves me correctly

 

If Tony could do it with a TFS head Y couldn't he do it with a better casting? Adjust the CNC program a bit Brodix BS Definitely has more meat around the Rock stands and require shaft rockers... No of a guy who ported a set of TFS castings and got it got thin Ls3 btw.

 

Mamofied TFS castings.....

 

Not sure. Call him and ask him. He will shoot you straight. No BS on his end of the phone.

 

I know .....that thought was for Rup. I've spoken to Tony on several occasions back in the day...got 2 right hand men on heads ER and Darin..don't forget Scott @ CFE.
Richard at WCCH's has a All Pro 290 cc head that flows 430's .... I say and think that port may go into the Brodix BR BS... @ a fraction of the cost. .... Save around $1000 depending on Richards CNC cost.

 

This thread may have been the inspiration for Tusky's cookbook.

 

After looking thru it again, I think you're right.