8.9s NA or Bust
#601
Boy I will bet that pass had the adrenaline pumping. Great Job!!!! Car looks great coming off the line and going down the track. Crank that launch rpm up to 5500 when your hooking that good. Those Menscers are definitely doing their job. I smell a 1.0x 60' if and WHEN you do spray it, you know your going to have to spray it right.
That is one Bad Bitch to say the least. I could not be more happy for you. Congratulations!!!!!!
That is one Bad Bitch to say the least. I could not be more happy for you. Congratulations!!!!!!
The following 2 users liked this post by TTur1996:
95sscamaro (05-28-2023), Che70velle (05-28-2023)
#602
Boy I will bet that pass had the adrenaline pumping. Great Job!!!! Car looks great coming off the line and going down the track. Crank that launch rpm up to 5500 when your hooking that good. Those Menscers are definitely doing their job. I smell a 1.0x 60' if and WHEN you do spray it, you know your going to have to spray it right.
That is one Bad Bitch to say the least. I could not be more happy for you. Congratulations!!!!!!
That is one Bad Bitch to say the least. I could not be more happy for you. Congratulations!!!!!!
The following users liked this post:
jayyyw (05-31-2023)
The following users liked this post:
jayyyw (09-14-2023)
#606
It’s time to dust the car off and get back to the track. There’s a test and tune next Saturday that I’m going to.
I have to change the oil, rear diff fluid, raise the rear up a touch, I’d also like to paint 2 small brackets
( nitrous ball valve in the car, oil tank), need to remove the dash and clean up some wiring and finish the nitrous wires. Last just need to run the purge lines and cut them for the nitrous.
Still not 100% on if I’m going to spray it but it would be nice to see what 1 kit would do.
I have to change the oil, rear diff fluid, raise the rear up a touch, I’d also like to paint 2 small brackets
( nitrous ball valve in the car, oil tank), need to remove the dash and clean up some wiring and finish the nitrous wires. Last just need to run the purge lines and cut them for the nitrous.
Still not 100% on if I’m going to spray it but it would be nice to see what 1 kit would do.
#608
any updates?