MerlinPro

Here is one of the first three saleable blocks. We expect the flow to increase in the next couple of weeks.
This is 9.24 deck, 4.125 bore.

BurnOut

iTrader: (1)

Very nice, man!! Bravo to you and the rest of the folks at World Products!!

Beast96Z

iTrader: (21)

Awesome. I'm sure it has been covered before, but how long are the sleeves you use?

MeentSS02

iTrader: (11)

Now to see what this community can do with them...looks great!

n2oJOE

iTrader: (1)

if you wanna let me test one in my vette ill pull my 408 right out

Bink

Beautiful!! Can't wait to see all the apps!

Can you post some NA Configurations and pricing. On the site I only see FI apps.

Tuf-Titan

Great job guys, can't wait to get one of these bad boys.

Firehawk441

iTrader: (41)

What is the largest stroke available in this block?

MerlinPro

Beautiful!! Can't wait to see all the apps!
Can you post some NA Configurations and pricing. On the site I only see FI apps
Bink,
At this time we're going to offer bare and short blocks only, for a while. We have no FI plans. Confused as to what site you refer to. Pricing for what we will have is at:www.theengineshop.com.
Fire,
4.500 fits and swings in the 9.24 deck but we'll wait for the 9.8 to test 481 CI.

pdd

iTrader: (3)

very nice, now if i could get this in my chrismas stocking id be all set

Bink

MerlinPro - I checked the site over the weekend (www.theengineshop.com). 3-4 LS shortblocks were listed and I thought it said something about reduced compression - I assumed FI .... - since the FI guys are drooling over your blocks .
Bottom of your Products page was Red Xs for me?? Oh well...thanks for the response.
Killer shortblock kits!

rookie89

iTrader: (1)

Who else carries these? Katech does as well right? Looks awesome btw. It sounds like you're suggesting to not use a 4.500" stroke in the short deck, that correct?

chuntington101

very nice work merlin! as sooo glad that all your hard work is finally coming to something for you guys!

can wait to see the big names get hold of these and find out how much they can take!

and roll on the 481!!!

Chris.

ScottyRocket

Bink,

Fuel Injection or Forced Induction? FI both ways. If is lower compresion, looks to be Forced Induction.

MrDude_1

iTrader: (4)

on the rear passenger side of the valley, there's a big boss cast in for something... what goes there?? i dont recognize it as anything... but im only used to genIIIs... not IVs.??

MerlinPro

MrDude,
On our block that's the relocated cam position sensor. The smaller one next to it in the corner is the oil sensor.

Wnts2Go10O

iTrader: (12)

aaa hell, awesome work. it wont be long before we see the full potential of these platforms.

383ss

iTrader: (14)

so have you guys determined the max bore on these yet?

Tuf-Titan

It would be nice if these bad boys could go 4.250 bore. Who knows they just might due to other blocks coming out with those bores.

DONAIMIAN

iTrader: (18)

Your gona need a kevlar stocking to hold that one

Looks good, cant wait to see what some of the financially inclined can do with these.