LME 408 Iron Block For Sale
#1
6 Second Club Moderator
Thread Starter
iTrader: (7)
Join Date: Sep 2002
Location: Lombard .IL
Posts: 3,682
Likes: 0
Received 0 Likes
on
0 Posts
LME 408 Iron Block For Sale
Less than 500 miles on it. It made 520's RWHP through a turbo 350 trans. 12 bolt, steel drive shaft and slicks. Motor peaks power at 6300 rpm. 13.5 -1 compression. Lunati crank and rods. Customs wisco nitrous pistons. LS6 oil pump, double roller chain, cam motion solid roller cam. I can sell just the shortblock or complete with heads intake lifers ect. The heads are set up for a solid roller. Pistons are gas ported. Motor is perfect. It's still in the car you can hear it run, check compression, oil pressure... whatever. Make an offer. I have two motors, one has to go. The other is a 427 that is being finished, third block from MTI!!! Brian at LME knows me and can answer or verify any info. I have original paper work and build sheet. Motor is less than a year old. Motor can be picked up or shipped. Thanks, Andy.630-531-5666.
Last edited by LASTLS1; 11-16-2005 at 01:34 PM.
Trending Topics
#12
6 Second Club Moderator
Thread Starter
iTrader: (7)
Join Date: Sep 2002
Location: Lombard .IL
Posts: 3,682
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by beardWS6
Sorry about that. Didn`t see his reply!
Last edited by LASTLS1; 11-16-2005 at 09:58 PM.
#17
TECH Apprentice
iTrader: (4)
Join Date: Nov 2001
Location: lebanon, ohio
Posts: 304
Likes: 0
Received 0 Likes
on
0 Posts
would you know the approx cost of the pistons that are in that motor? or would LME be the best source to talk to. I'm building a motor very similiar to that, already have most of the parts and am having trouble finding pistons setup for that high compression.
#18
6 Second Club Moderator
Thread Starter
iTrader: (7)
Join Date: Sep 2002
Location: Lombard .IL
Posts: 3,682
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by KMStevens
would you know the approx cost of the pistons that are in that motor? or would LME be the best source to talk to. I'm building a motor very similiar to that, already have most of the parts and am having trouble finding pistons setup for that high compression.
#20
6 Second Club Moderator
Thread Starter
iTrader: (7)
Join Date: Sep 2002
Location: Lombard .IL
Posts: 3,682
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by KMStevens
thanks a lot, really appreciate the fast response!
TTT for ya!!
TTT for ya!!