trans came out of my trans am that i built with all PTS hard parts.
Parts list
PTS billet servo
alto h/d 2 3/8 band
.400 and .570 boost valves
13 vane pump with hardened pump kit and rings
PTS 300m band anchor
PTS direct drum with blue clutches
PTS hardened stator
PTS shift kit
PTS deep alum pan
PTS p/r valve and p/r spring
4l60e reluctor wheel milled to fit output shaft
New TV cable
Yank PYE3600 converter
built nitrous ready driveshaft

All has maybe 200-300 miles and maybe 10 passes on it.
I have every bit of $4000 plus in this swap

Let it go for $1800 shipped.

Will take some parts as partial trade like
10inch th400 converter
comp 918 springs
z06 cam
750 DP holley carb

 

How much HP is it good to? I may be interested for my turgbo build-up.

 

If your planning more then 700rwhp i would go th400 but if your doing a mild turbo setup then this will hold just fine. Most buick GN guys get to about low 10s/high 9s and swap to th400s too.

 

Thats what I needed to know. I guess I will stick with my built 4L65E. I was hoping your TH2004r would hold more. I had PST quote me one and it ended up being like $3900.

 

Someone make reasonable offer.

 

back up top

 

still for sale

 

had a few PMs but still for sale.

 

back up top for today.

 

back up today

 

what kida drive shaft and how much for it?

 

Shaft is a 3in steel with splicer u joints, built buy driveshafts unlimited in St. Louis Mo. Same parts they use for local cars that run deep into the 8s. I've got $350 in it, I'll take $225 plus shipping.