Rears have a half a coil cut out of them. Pics in my cardomain site without rear isolator. They measured 27 1/4" in the rear with isolators and 25 3/8" in the front. They were too low with my TD's, so I went with Hotchkis instead. There is also a pic of the car on the DMS website. $100 plus shipping.

 

Back up to the top...

 

how much of a drop did this make on the front?

 

The front was really low. I didn't take measurements before, so I couldn't tell you exactly. I never had a problem with my LT headers scraping or anything. Just back where the x-pipe is and the muffs (hangs low). I think the picture on their website is before I had my alignment; that raised it back up a little.

 

How old are they? How many miles are on them?

 

Dude, I can't believe you cut them or I woulda bought them already. Should only have been about 1" all the way around or so, about what BMR does.

 

Not sure what the drop was. Measure a stock height car, then subtract the difference. The front dropped way more than an inch. I wanted to get the drop in the rear close to the front. The only way to do that was to take not only a half a coil out but remove the rear spring isloators. It gave it a really nice stance, it was just too low once I put on the TD's.

 

Id buy the fronts if you will seperate? If not TTT for ya!

 

I'd like to sell them as a set. Thanks.

 

PM sent.

 

Back atcha.

 

I think we should turn them into pogo sticks

 

You're sister's a pogo stick! Sale pending, ***!

 

You need to come pay me a visit. It is all kinds of good times up here.

 

hmmmm....