Is it complete from intake to pan? Was any boost ran on this motor and is it still in the car?

 

The four thumbnails in response#18 show what is included. It is the longblock only with timing cover, rear and upper cover installed along with cam sensor, oil pump, timing chain, rockers, etc. You need your own pan, intake and accessories.

It has been run briefly with a twin turbo kit just doing preliminary tuning. It pegged the maf at a very low boost level and there isn't any speed density 2 bar tuning for the LS2's except using an aftermarket computer, so I put the car back to stock and ordered a new Z06.

The engine is on a stand at this time.

 

got an ls2 manifold?

 

No I do not. I had this built as a replacement for the stock LS2 in my 05 GTO, so I swapped the pan, intake, etc.

Jody

 

bump

Jody

 

this is what i need but my mod season doesnt start till late fall.... good luck on the sale!

 

Thanks!

Jody

 

TTT for ya

W2W makes some badass motors!

 

I think they do great work, which is why I used them. The engine ran flawless.

Jody

 

What would need to be done for a complete install in an LS1 car? Where are you located?

 

You would bolt your oil pan, intake, and accessories to this LS2. I believe you'd need knock sensor wiring adapters as they are in a different place (about $45) or use the LS1 knock sensors.

I'm near Sacramento Ca. but have a sale pending as of late last night.

Jody

 

Sale Pending

 

Is she sold?

 

Depends on if the money shows up Monday/Tuesday. Appears to be sold.

Jody