New Darton MID block, New All Pro Heads, T+D rockers, Callies crank, etc.
05-30-2007 | 03:56 PM
#1
Thread Starter
9 Second Club
iTrader: (9)
Joined: Nov 2001
Posts: 570
Likes: 0
From: St. Charles, MO
New Darton MID block, New All Pro Heads, T+D rockers, Callies crank, etc. Decided to go a different direction for now.
Fresh Darton MID block (new) that just came back from the machine shop finished honed to 4.146 and line bored. Finish machine work was done locally, the sleeve install and boring was done by Steve at Race Engine Development. This block is ready to be built. $3200.
All Pro heads (new) purchased these from Futral motorsports and they are set-up for a solid roller (good to .750) these are brand new. Heads flowed .340/.245 at .700 lift., 2.1 intake valves and 1.6 exhaust, hand finished by Larry Meaux, New GM carb intake set-up for FI that has also been port matched to these heads by Larry Meaux. $3500 for heads and intake.
Callies 4'' crank used but in good condition = $1200
Diamond 4.125 pistons (-2cc reliefs) used but in good condition = $350
T+D shaft rockers (new) bolted on motor several times to check clearence = $800
Shipping is not included in these prices and I would consider a better price on a package deal.
Looking for a built 346 long block so a trade may be possible?
Thanks,
Brian
Fresh Darton MID block (new) that just came back from the machine shop finished honed to 4.146 and line bored. Finish machine work was done locally, the sleeve install and boring was done by Steve at Race Engine Development. This block is ready to be built. $3200.
All Pro heads (new) purchased these from Futral motorsports and they are set-up for a solid roller (good to .750) these are brand new. Heads flowed .340/.245 at .700 lift., 2.1 intake valves and 1.6 exhaust, hand finished by Larry Meaux, New GM carb intake set-up for FI that has also been port matched to these heads by Larry Meaux. $3500 for heads and intake.
Callies 4'' crank used but in good condition = $1200
Diamond 4.125 pistons (-2cc reliefs) used but in good condition = $350
T+D shaft rockers (new) bolted on motor several times to check clearence = $800
Shipping is not included in these prices and I would consider a better price on a package deal.
Looking for a built 346 long block so a trade may be possible?
Thanks,
Brian
Last edited by DOC OTIS; 06-06-2007 at 12:38 AM.
05-31-2007 | 03:57 PM
#6
How do I find out if the rotating assembly will work in my block? Don't mean to ask stupid questions but I've never actually done a shortblock. I'm assuming the crank with the rods and pistons would make a 427 in my 4.125 bore block, but how do you confirm that? Wouldn't I need to take the block out and to a machine shop and measure it out to buy pistons for it?
