whats the size on the turbo?

 

They are GT2871R turbos. Here's the info from ATPturbo.

Turbine
-Wheel: 53.85mm w/ 76 trim
-Housing: .86 or .64 ar
-Maps

Compressor
-Wheel: 71mm w/ 56 trim
-Housing: .60 ar

 

Ttt...

 

Pm sent on forged motor.

 

replied to pm's

 

Yes, I am willing to negotiate the price if someone buys the 347 and the turbo kit. Even better deal if you buy them with the Camaro.

 

nice stuff.

 

Thanks.

 

This kit does NOT require an aftermarket K-member. You can use your stock one, KEEP YOUR A/C, and power steering and still make UNBELIEVABLE RWHP!!!

 

Still for sale.

 

So how much would you ask for a package deal,Camaro / Forged motor /Incon turbo kit?
Everything you got.

Dave

 

what dish are those pistons?

 

very nice setup. cost less than my stroker motor! good luck.

 

The pistons are dished -8.6cc's. Thanks SSIRBY.

 

Good luck with the sale.

I'm interested in the short block, what head cc do you have?
What compression did you get with the -8.6cc pistons?
Very interested - can come and pick it up.



If any one is interested, I've been running my incon kit since 2003.
Never a problem. Runs like stock, gets stock mpg in till you nail it.
Still on the stock bottom end - 8 lbs boost - 575rwhp
I run it a bit rich to be safe...

 

replied to pm's.

I was going to use a set of 317 heads (72 cc's) which made my compression ratio 9.03:1 with .040 thickness headgaskets with the -8.6 cc pistons.

 

how far are you from akron ohio 44321? i was going to run a single turbo....but if you arent too far i might end up going TT. thanks

 

I'm guessing I'm about 6 hours from Akron. It's about 2 1/2 - 3 hours to here from Pittsburgh. As of yesterday though, the kit is pending sale until I get back from visiting my friend on Monday, and there is a guy 2nd in line after that.

 

Turbo kit not for sale anymore

 

TTT... 347 and Z28 still for sale.