Plugging hole in timing cover left by E-wp.
#21
I took some jb weld and made a thin strip of it, then put it around the hole. Put the quarter in and smashed it down into the jb weld, causing it to squish up. Then I smoothed it out. Put some on the back side too.
#23
#25
TECH Fanatic
Thread Starter
iTrader: (9)
Join Date: Mar 2006
Location: N. Richland Hills
Posts: 1,266
Likes: 0
Received 0 Likes
on
0 Posts
Well I'm not worried about it coming off and going around the chain b/c the old seal is still there and there's only an 11/16 hole. I'll be doing it here in about 30 mins. and then the wp goes back in and the oil pan comes out and gets cleaned. I might just get this thing running today