O2 question
O2 question I just put long tubes on my car and I extended the o2 wiring by cutting and soldering. On the passenger side I forgot to mark the two brown wires so I would know which one was which when I soldered them back together. Would it make a differance if they got swapped?
According to this diagram:
http://shbox.com/1/HO2S_connector.jpg
I don't think it matter if you mix up the two brown wires. They are for the heater circuit.
http://shbox.com/1/HO2S_connector.jpg
I don't think it matter if you mix up the two brown wires. They are for the heater circuit.
TECH Regular
Joined: Apr 2007
Posts: 420
Likes: 0
From: Kempner, TX
According to this diagram:
http://shbox.com/1/HO2S_connector.jpg
I don't think it matter if you mix up the two brown wires. They are for the heater circuit.
http://shbox.com/1/HO2S_connector.jpg
I don't think it matter if you mix up the two brown wires. They are for the heater circuit.
Jake
West Point ROCKS!
Last edited by JAKEJR; May 7, 2009 at 12:45 PM. Reason: Specified 3 wire heated 02s
