Flat or square O2 extensions?
Thread Starter
Rockstar
iTrader: (15)
Joined: Feb 2009
Posts: 1,582
Likes: 0
From: I'm on a boat! in Shreveport, La
Flat or square O2 extensions? Simple question. Any takers?
It's a 94 BTW, so I only need fronts, but do I need one or two extensions seeing as how 94's only had 1 cat?
It's a 94 BTW, so I only need fronts, but do I need one or two extensions seeing as how 94's only had 1 cat?
Thread Starter
Rockstar
iTrader: (15)
Joined: Feb 2009
Posts: 1,582
Likes: 0
From: I'm on a boat! in Shreveport, La
Trending Topics
Thread Starter
Rockstar
iTrader: (15)
Joined: Feb 2009
Posts: 1,582
Likes: 0
From: I'm on a boat! in Shreveport, La
I could, but if it falls apart down the road I'd just be kicking myself for doing something half assed when I could have gotten it all done the right way the first time. And it'll look better this way, like factory, kind of.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
TECH Veteran
Joined: Dec 2008
Posts: 4,147
Likes: 62
From: Little Rock, AR
You don't ever want to alter the wires attached to the O2s. They are an important part of how the O2s work by drawing in reference air between the wire and insulation. They also use stainless steel wire. If you want to do your own extending, do it on the car's harness side. Extensions keep you from hacking up the car's harness (always a good thing).
Yeah you only need a few inches on the pass. side. Depending on your setup, driver side should fit fine (mine fit but was a bit tight so I made my own extensions. Like 8" on one side and 10" on the other side, way too long but it works.. one of these days I'm going to re-do them for a perfect fit)
Last edited by 1badzee; May 11, 2010 at 07:50 AM.
Thread Starter
Rockstar
iTrader: (15)
Joined: Feb 2009
Posts: 1,582
Likes: 0
From: I'm on a boat! in Shreveport, La
Thread Starter
Rockstar
iTrader: (15)
Joined: Feb 2009
Posts: 1,582
Likes: 0
From: I'm on a boat! in Shreveport, La
