383 stroker .060 LT1 build
06-02-2010, 10:09 AM
#41
.060 is not a good idea. I had a used block that I got and the machine shop wouldn't touch it cause it was already .040. He said if your panning on doing any " hot roding" goin anything over .040 is not a good idea. And I thought a 400 crank and .060 on a sbc would be a 396. So wouldn't .040 be a 388?
Have fun.
Jake
06-07-2010, 08:42 AM
#42
Launching!
Thread Starter
iTrader: (6)
Join Date: May 2010
Location: Lake Norman, NC
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
I got the block back yesterday from being line bored for the 4 bolt. Turned out great! Gonna get it cleaned up, painted red and start assembley. My motor guy should have the short block done by Tuesday night. Thats the plan anyway 
[IMG]
[/IMG]
[IMG]
[/IMG]
[IMG]
[/IMG][IMG]
[/IMG] 
01-22-2012, 03:10 PM
#49
Launching!
Thread Starter
iTrader: (6)
Join Date: May 2010
Location: Lake Norman, NC
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
Thanks 
It's pace setter headers
Car runs like a champ
http://www.youtube.com/watch?v=MjwHI...e_gdata_player
http://www.youtube.com/watch?v=cwoPD...e_gdata_player
It's pace setter headers
Car runs like a champ
http://www.youtube.com/watch?v=MjwHI...e_gdata_player
http://www.youtube.com/watch?v=cwoPD...e_gdata_player
01-23-2012, 08:31 AM
#51
Launching!
Thread Starter
iTrader: (6)
Join Date: May 2010
Location: Lake Norman, NC
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
If I went now I probably wouldn't make it off the line. Stock rear end lol
