intake elbow
Thread Starter
Launching!
Joined: Oct 2010
Posts: 240
Likes: 0
intake elbow My stock intake elbow is torn where it clamps to the TB. I want to replace and good suggestions? I already have a cai and got rid of the air silencer and plugged it. I still have the big bulky baffle any suggestions on getting rid of that also? Thanks.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
lol im sure you believe that too dont you? I like the jegs powder coated one, i used a trickflow stained one before and the CAI would not fit correct for me and i had to trim the elbow some for better fitment. But if i had to do it again i would just buy a silicon elbow that was 4in to 3in and go that route since silicon dont hold heat like metel does and its much cheaper than an LE1 elbow. plus you can get them in a few diffrent colors at www.Siliconintakes.com for right around 25 bucks. And you will only have one clamp onm each end so it cleans it up some and talking about cleaning up the silicon is very simple to keep clean as well.
On The Tree
Joined: Dec 2010
Posts: 166
Likes: 0
[QUOTE=killerz97;14638887]On the silicon intakes how do you connect the vacuum line for the opti? Do you just drill a hole in it?[/QUOTE
for that my friend you are going to drill a hole in their, i had to do it in mine
for that my friend you are going to drill a hole in their, i had to do it in mine
Yes i think every aftermarket elbow needs the little hole drilled into it. i would poke a very small hole and push it in snug. the silicon ones are very nice in my opinion and look sharp as well
I believe hes just talking about for the outside of the silicone coupler. IIRC the mouth of the TB is 4" and the MAF is 3.5".... atleast thats what it is on my car. You can try to find a silicone turbo adapter 4" to 3.5" in a 90. that should fit onto everything ok. But it might be to tight of a radius. im not sure
On The Tree
Joined: Feb 2011
Posts: 121
Likes: 0
From: Orland Park
I believe hes just talking about for the outside of the silicone coupler. IIRC the mouth of the TB is 4" and the MAF is 3.5".... atleast thats what it is on my car. You can try to find a silicone turbo adapter 4" to 3.5" in a 90. that should fit onto everything ok. But it might be to tight of a radius. im not sure
