Originally Posted by 96capricemgr

Let's throw out there the likelyhood of needing new seats since LT1 heads need them for a 2.02 valve I have to believe LT4 heads would need new seats for a 2.08 valve. Haven't seen anyone try it but I doubt you will find flaw with the reasoning.

Originally Posted by Jerry Clayton

I don't believe you'll get them in the head if they are in stock location----if you do--they will be severely shrouded by the chamber wall and cylinder wall(if they clear)
On heads with bigger valves you will find that the intakes are moved toward the center of the chamber and the exhaust valve is moved even further over to give the intake room in between them

then there is the issue of your piston's notches aren't big enough for 2.080 valve and if they were they probably aren't in the right location

Originally Posted by joshh123

dude.. please stop with the bullshit. these heads have had 2.08's in them for the past 3 years. and have been run. and put out 447rwhp and 441rwtq only revving to 5700rpm. so please.. please stfu about it. the heads were done by LE. i am sure he knows what he is doing. how about we stay on the topic.

Originally Posted by andrew ws6

Why not just call Llyod and ask him? You have not responded to anyone other than 96capricemgr seems like this thread was to start an arguement.