Arp head an main stud questions..
#21
Thread Starter
TECH Fanatic
iTrader: (11)
Joined: Sep 2005
Posts: 1,954
Likes: 1
From: fort walton beach,fl
At this point what should I do? Should I back the nuts off and retorque them all to 80 to make sure they are not over torqued and causing deflection/distortion of the caps? Or Should I tighten them even lower to factory bolt spec ? Certainly they wouldn't cause an issue at factory spec I would think...? Is there a sequence like on heads to tightening the mains.. I know the paperwork says 3steps to 80 .. There is no one in this area I can trust go to for changes and I'm not broke by any means but I certainly don't have law suit money.. Flame suit On.
#22
At this point what should I do? Should I back the nuts off and retorque them all to 80 to make sure they are not over torqued and causing deflection/distortion of the caps? Or Should I tighten them even lower to factory bolt spec ? Certainly they wouldn't cause an issue at factory spec I would think...? Is there a sequence like on heads to tightening the mains.. I know the paperwork says 3steps to 80 .. There is no one in this area I can trust go to for changes and I'm not broke by any means but I certainly don't have law suit money.. Flame suit On.
i would not back off the torque. if you run to little the bolt will come loose. remember that torque is only a means of achieving the proper bolt stretch. to much or to little will cause the fastener to fail in one way or the another.
#24
Thread Starter
TECH Fanatic
iTrader: (11)
Joined: Sep 2005
Posts: 1,954
Likes: 1
From: fort walton beach,fl
Ok, talked to lyle the owner at smiths performance in Holt FL a performance machine shop about an hour from here right near the race track and he knows all to well about rpm's negligence .. Because he has one of their failed motors there now, he told me since i have rotated the motor to pop one cap at a time and check the bearing for uneven shiny spots which would indicate an outta round bore.. Once more I could also take plastigauge and verify oil clearance , then get back to him.. Or retorque to 80 with moly. So that's what I'll do..