What to look for in a coil? milliamps? peak voltage?
#21
I know, I'm beating a dead horse. But I have to ask, 7.9 amps from a coil?!
http://www.summitracing.com/parts/PNX-D3002/
Primary Resistance 0.310 ohms
Maximum Voltage 45,000 V
Turns Ratio 100:1
Secondary Resistance 6.8K ohms
Inductance 3.1 mH
Peak Current 7.9 amps
Spark Duration 1.5 mS
http://www.summitracing.com/parts/PNX-D3002/
Primary Resistance 0.310 ohms
Maximum Voltage 45,000 V
Turns Ratio 100:1
Secondary Resistance 6.8K ohms
Inductance 3.1 mH
Peak Current 7.9 amps
Spark Duration 1.5 mS
#23
8 Second Club
iTrader: (2)
I know, I'm beating a dead horse. But I have to ask, 7.9 amps from a coil?!
http://www.summitracing.com/parts/PNX-D3002/
Primary Resistance 0.310 ohms
Maximum Voltage 45,000 V
Turns Ratio 100:1
Secondary Resistance 6.8K ohms
Inductance 3.1 mH
Peak Current 7.9 amps
Spark Duration 1.5 mS
http://www.summitracing.com/parts/PNX-D3002/
Primary Resistance 0.310 ohms
Maximum Voltage 45,000 V
Turns Ratio 100:1
Secondary Resistance 6.8K ohms
Inductance 3.1 mH
Peak Current 7.9 amps
Spark Duration 1.5 mS
Did you ever get a different coil? I have two of the newer MSD sealed units(one used, one new pn8226). I run a Pro power off a 7AL-3 now. I also have an Dig 6(older model, used pn6520) and the Dig 6AL(new model, never used pn6425) for the LT1.
#24
Yea I don't think so. Looks like a stock one to me. No way that could support that amount of amps.
Did you ever get a different coil? I have two of the newer MSD sealed units(one used, one new pn8226). I run a Pro power off a 7AL-3 now. I also have an Dig 6(older model, used pn6520) and the Dig 6AL(new model, never used pn6425) for the LT1.
Did you ever get a different coil? I have two of the newer MSD sealed units(one used, one new pn8226). I run a Pro power off a 7AL-3 now. I also have an Dig 6(older model, used pn6520) and the Dig 6AL(new model, never used pn6425) for the LT1.
One of the MSD reps recommended the Dig 6AL with the Blaster HVC coil.
I haven't done anything yet cause I'm in no rush.
#25
8 Second Club
iTrader: (2)
No. Never changed it. The plan is to swap in autolite AR104's gapped @ .050 with a hotter coil. The Crane coil I have is crapping out and had to decrease the plug gap to stop it from misfiring at high rpm. It worked but I know the bigger the gap the better.
One of the MSD reps recommended the Dig 6AL with the Blaster HVC coil.
I haven't done anything yet cause I'm in no rush.
One of the MSD reps recommended the Dig 6AL with the Blaster HVC coil.
I haven't done anything yet cause I'm in no rush.