smooveZ

Planning on having my Stainless Ebay headers installed on my 95Z but was wondering if I can still use K&N type oil filter or would I have to use a stock type of filter??

smitty2919

Stick with AC Delco and be done with it.

wvtireburner

I did use the taller truck filter but after my obx stainless ebay headers and 7 qt oil pan the stock filter is tight but it does work.

Purple Poncho

iTrader: (1)

From what I have seen most all of the eBay stainless headers force you to use a short oil filter.

smooveZ

Who actually made these headers and ypipe because they fit like crap. We had to BFH the passenger side header to make it fit over the ac line and the drivers side header tucks so close to the floor board that the ypipe would bearly fit onto the header. We had to heat it up that spot of the ypipe and BFH it to fit around the floor board support underneath the brivers seat. The end of the ypipe is 3 inches and so is my Magnaflow! They would not connect! We are having the ypipe end exspanded to slip over the Magnaflow pipe. I look will not recommend anyone buying these!! Should have got the Kooks brand!! The up side to this is they look cool in the engine compartment with the rest of the bling.

marlar98

Which eBay headers are they? Just curious

ShovelMan

I'd like to know as well please.Link us to the store.

smooveZ

Phab stainless LT1 headers on ebay. They also make a true dual catback system for LT1 cars also. I love the headers so far but what a pain to install them! I think the Kooks brand would have been a little easier to work with. Is there anyone using the Kooks brand on there LT1 car on this website??

Fuhnortoner

These are cheap enough to make me wanna try em out.

http://www.ebay.com/itm/Chevy-LS-4-8...NZQ-Rq&vxp=mtr

smooveZ

Those aren't LT1 headers.

leadfoot4

iTrader: (1)

Not even close!!

Fuhnortoner

Here then *******.

http://www.ebay.com/itm/Chevy-Camaro...BXdurJ&vxp=mtr

smooveZ

Now that's better!

smitty2919

You are surprised that ebay stainless headers don't fit like a glove...jesus. Buy cheap ****, get cheap ****.

I thought Pacesetter were cheap, but at least they fit fine.

smooveZ

Well at least I will not have to worry about getting a another set for a very long time. No part really ever fits right when you modify your ride. There is always something that is not going to fit correctly.

ShovelMan

Will LT headers fit at stock height with 17 inch wheels?

96lt1m6

iTrader: (31)

Non-issue

Daves03

how are those headers holding up i like the stainless look i just dont know what headers are on my car i have to change the motor and may buy some to put on it

MuhThugga

Just be careful with the eBay headers and verify the primary and collector sizes. A lot of them are 1.5" primaries.

smooveZ

Had them on my Z since last April and not one issue. ��