**Need help (383 Stroker Kit)**
**Need help (383 Stroker Kit)** hey Im fixing on to get a 383 Stoker kit on My 95 Trans am....
Would this fit????
does it need anything else for it to work?
http://cgi.ebay.com/ebaymotors/Crank...QQcmdZViewItem
Would this fit????
does it need anything else for it to work?
http://cgi.ebay.com/ebaymotors/Crank...QQcmdZViewItem
Just out of curiousity, why aren't you upgrading to forged pistons? That way you'll be set for a power adder at some future point.
As a kit, it's pretty complete, but I don't think it will work because you should have a 1-piece rear seal and this crank is set up for the older style 2-piece. You would have to run an adapter.
If you go that route, you should have the rotating assembly balanced - see if the assembly can be internally balanced. You'll have to clearance your block for the stroker crank.
Just some quick thoughts.
Jim
As a kit, it's pretty complete, but I don't think it will work because you should have a 1-piece rear seal and this crank is set up for the older style 2-piece. You would have to run an adapter.
If you go that route, you should have the rotating assembly balanced - see if the assembly can be internally balanced. You'll have to clearance your block for the stroker crank.
Just some quick thoughts.
Jim
Teching In
Joined: Apr 2005
Posts: 49
Likes: 0
From: NEW MEXICO
No it will not work.Do some more research on kits for that LT1. www.strokerkits.com look for 1piece seal for LT1's. O and get a good balanced kit cause I tried to get one of the kits off of ebay and I had hell getting the right one.
