LT4hotcam

Hey guys i have a 355 LT1 With milled heads, A4, 3.23 Gears, And the LT4 HC kit and i was wondering what should my RPM range be and what it should pull to?

94Z28Joe

when i had mine it was still making power at 6200k where I had the msd box set to red line at when it was on the dyno

LALT1

iTrader: (1)

AMEN to that, that was by far the best running hot cammed car I head ever seen!!

jmill96Z

iTrader: (3)

I agree, mine pulls up to 62-6300. That's right about where my peak is on the dyno

TRIPOWER1

i havent installed my hot cam yet, but my bolt on 95z 3.23 a4 with a tune pulls to 6k is that normal? sorry LT4 didnt meen to highjack the thread.

LT4hotcam

Its cool dude.

94Z28Joe

thanks travis

the_merv

iTrader: (88)

I was going to 6200 with my setup. How much did you have your Heads Milled?

94Z28Joe

Mine weren't milled. had Crawford's port work done thought

fastbird96

iTrader: (1)

Mine peaked at 6200 on the dyno also.

ele-blue95

iTrader: (10)

Ive pulled mine to 6200-6300. Mine has seen 6400-6500 here and there.

01WS6/tamu

iTrader: (37)

On my car it pulled hard to about 6300 I never wanted to push it much farther but for all the haters out there it was a damm nice good running economical cam.

LALT1

iTrader: (1)

I always forget yous is a hot cam car, yet another car that just flat out pulls great out on the HWY!!!

robby73z28

whats a lt4 hot cam wat lift

robby73z28

wats a lt4 hot cam wats the lift

plaf713

iTrader: (8)

218/228 525/525

solarofthesix

iTrader: (1)

mine was pulling hard till about 6500 when I blew the clutch into 1000000 pieces. Blown about 1 car length after the 1/8 it ran a 15.4. Hotcam Kit, K&N CAI, TUNE, and LCAs(hotpart.com) pushe don a stock rear, steal driveshaft on a 6 speed, I didnt dump the clutch or launch hard off the line. Ive taken it to 62-6500 several times, so i think it was on its way out anyways. But it definately still pulls at 6200