I was wondering what you guys with ported heads use. I had a set of percy's which worked AWESOME, but realized the ports in the gaskets are smaller than my ports on the head. I thought about cutting them out, but that would take out where it seals around the port. I would prefer a MLA gasket like the percy's but not sure if there is one out there.

 

I'm running the Mr. Gasket copper race gasket (square ports)

 

I used the felpro 1406, the large d-port that fit my header flange even though my heads are stock.

 

sweet ill have to check on those when i get to work today.

1badzee- you dont have any issues with leaking?

 

Mr. Gasket #5716