My T-56 and Engine hate each other.
#22
From that thread!
Thats the one I got sent by SPDC!... that's the big and wrong one right? That's what the thread says but I'll be damned if I dont want someone to confirm its wrong. LOL If so then I feel retarded for having the wrong pilot bearing installed this entire time... I've seriously spent like 3 months fustrated at this thing.
And for the requested pics... sorry they are huge btw... but I figured details were important.
.
Thats the one I got sent by SPDC!... that's the big and wrong one right? That's what the thread says but I'll be damned if I dont want someone to confirm its wrong. LOL If so then I feel retarded for having the wrong pilot bearing installed this entire time... I've seriously spent like 3 months fustrated at this thing.
And for the requested pics... sorry they are huge btw... but I figured details were important.
.
On and BTW, you don't want any grease on your input shaft like that. (I know you were probably frustrated at it not sliding) You'll want to brake clean all that off before the final install..
#24
Time to pick up a new pilot tomorrow. I hate when little things cause a cascade of crap!
#27
Yea that's definately your problem. BTW..stick a Speed Bleeder on that thing while you are there..trust me they are worth their weight in gold.
Man SDPC has been sinking the Failboat lately. They owe you a Bell Housing..
Get them to send you a free Speed Bleeder instead.
Man SDPC has been sinking the Failboat lately. They owe you a Bell Housing..
Get them to send you a free Speed Bleeder instead.
#29
Yea that's definately your problem. BTW..stick a Speed Bleeder on that thing while you are there..trust me they are worth their weight in gold.
Man SDPC has been sinking the Failboat lately. They owe you a Bell Housing..
Get them to send you a free Speed Bleeder instead.
Man SDPC has been sinking the Failboat lately. They owe you a Bell Housing..
Get them to send you a free Speed Bleeder instead.
#31
Also, and maybe it was pictures, but your dowels ON THE TRANNY...look cocked/crooked (not straight). Again, maybe teh pics, but if those pins are crooked you will NEVER get it to go in...
I know that the PB issue was/is your problem, but double check those dowels again as well...
I know that the PB issue was/is your problem, but double check those dowels again as well...