corvette ls1 with camaro t56
#1
Teching In
Thread Starter
Join Date: May 2010
Location: Lebanon Illinois
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
corvette ls1 with camaro t56
i recently purchased a 00' corvette ls1, and i plan on purchasing a 00' camaro t56.
will these bolt up/together without a problem? anything need to be modified? all of the threads i am reading have conflicting information.
also, the LS1 i have was on an automatic car. anything special need to be done to the ls1 for the flywheel installation?
thanks
will these bolt up/together without a problem? anything need to be modified? all of the threads i am reading have conflicting information.
also, the LS1 i have was on an automatic car. anything special need to be done to the ls1 for the flywheel installation?
thanks
#4
TECH Addict
iTrader: (11)
The pilot bearing is just the small bearing that sits in the center of the crank at the end of it (where the flywheel is basically). The transmission input shaft slides into the center of the pilot bearing.
This article shows it for a T56
http://www.gmhightechperformance.com..._v_clutch.html
This article shows it for a T56
http://www.gmhightechperformance.com..._v_clutch.html
Last edited by Red99TA; 09-03-2010 at 12:35 PM.