Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

LT1 pecking noise when clutch is fully in?

Thread Tools
 
Search this Thread
 
Old 02-24-2013, 08:58 PM
  #1  
10 Second Club
Thread Starter
 
VandykeT/A's Avatar
 
Join Date: Jan 2010
Location: Hurley, VA
Posts: 2,317
Likes: 0
Received 20 Likes on 17 Posts

Default LT1 pecking noise when clutch is fully in?

Its a friend of mines car. When he bought it the throwout bearing was pulled apart and the master cylinder rod was broken into. Well we put a complete clutch kit in it, new master, and new slave. After that the clutch worked great except for when you press the clutch completely to the floor. It makes a pecking noise but only the last 1/4" over travel. It fully releases and everything. Just the noise. What could it be? We're thinking about making a spacer for the slave out of some aluminum.
Old 02-24-2013, 09:01 PM
  #2  
TECH Addict
iTrader: (11)
 
Zlow28's Avatar
 
Join Date: Apr 2010
Posts: 2,081
Likes: 0
Received 1 Like on 1 Post

Default

did you replace the pilot bearing? And if you did, did the transmissions input shaft look good?
Old 02-24-2013, 09:04 PM
  #3  
10 Second Club
Thread Starter
 
VandykeT/A's Avatar
 
Join Date: Jan 2010
Location: Hurley, VA
Posts: 2,317
Likes: 0
Received 20 Likes on 17 Posts

Default

Yea we replaced it. The pilot was wore but the input looked good from what I remember.



Quick Reply: LT1 pecking noise when clutch is fully in?



All times are GMT -5. The time now is 06:52 AM.