What's the drill mod
You have to remove your Master,(if it's never been removed this is a pain in the ***)
There is a Clip ring that you can't see, but once you know about it, well it's easier.
You have to disconnect the line from the Slave from under the car. Its a Quick disconnect.
once the whole thing is out.
you remove the Line from the Master , by punching out a pin, then you drill out the inside of the fitting that goes into the master.
Make sure you get all the Crap out , put it all together , bench bleed the master.
You might need the Step by step. I'm gettin tired of typing.
Didn't install university have this too?
I'll check
Trending Topics
Goto www.intalluniversity.com
Hit the intall documents button on the left under Main.
Then scroll down to Transmission
look for Drill mod, mcleod master install.
The Best V8 Stories One Small Block at Time
http://www.chevyhiperformance.com/howto/39021/
Mods, can we sticky stuff like this?


