Earlier today I had a braided hydralic line become disengaged from the clutch master cylinder while pulling up to a light. I have checked for some TSB's or recalls but have not found any and you have to "of course" buy the complete master cylinder. Has anyone else had this happen?

 

Found it. The braided line is held in by a roll pin. Instead of gettng the dealer to install the new master ($600) think I will have the car towed back for the $65.00, do the drill mod and then replace the pin which I hope just vibrated out. Does anyone know what size o-ring is used to connect the braided line to the master just in case its missing?

Thanks
fEz