Suggestions on what to do next...
Thread Starter
Joined: Oct 2007
Posts: 446
Likes: 1
From: Oakland, California
I somehow forgot that I have two LSX engines sitting on stands, and one that I tore apart because of water in the cylinders, so I actually have three sets of GM flexplate/flywheel bolts haha.
9 Second Club
Joined: Nov 2003
Posts: 13,616
Likes: 185
From: Norn Iron
It is possible there are variances...but I've already posted what a normal GM flywheel bolt looks like, as has the user with his above.
Thread Starter
Joined: Oct 2007
Posts: 446
Likes: 1
From: Oakland, California
Thanks for all of the help guys. It's been raining out here, so I haven't had a chance to get these installed. I'm going to go ahead and start taking measurements for the throwout bearing.
I'll check back in with the progress. This might helps other folks in the future.
I'll check back in with the progress. This might helps other folks in the future.
