T56 swap master cylinder reinforcement
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Aug 2012
Location: Central Illinois
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
T56 swap master cylinder reinforcement
I went A4 to M6 in my 96 TA awhile back. I’m in the middle of a LS swap at the moment and I’m redoing the engine bay.
I want the reinforce the the point where the clutch master cylinder mounts. I’ve done a few quick searches and I’m not seeing any ideas that I want to follow. I am wanting to weld a steel plate to the firewall. But I would like to see a few ideas of how people have done it. I can weld inside or outside I would just like it to look queen . Post pictures if you have them please.
I want the reinforce the the point where the clutch master cylinder mounts. I’ve done a few quick searches and I’m not seeing any ideas that I want to follow. I am wanting to weld a steel plate to the firewall. But I would like to see a few ideas of how people have done it. I can weld inside or outside I would just like it to look queen . Post pictures if you have them please.