So we got finished installing a McLeod Twin Disk yesturday and it needed to be blead.

Friend thought the slave was an 8mm, I couldnt get it with the wrench so I tried to size it up to the slave.
AND IN IT WENT! Heard it hit the bottom of the bellhousing. Any way to get this out without removing the tranny?

If not, Procharged LS1 for sale with 8mm socket in the bell housing.

 

probly have to pull the tranny back..i had that happen once and it landed on one of the ribs inside. once i moved it back a bit it fell right out.

JR

 

I got a $5,001 check with your name on it for your defective car.

Good luck!

(never did find my 15mm impact socket after a clutch swap in my wife's car... )

 

for anyone out there this happens to, pull your starter out and fetch it out with a pen magnet...........