New code problem
Thread Starter
TECH Apprentice
iTrader: (15)
Joined: Nov 2003
Posts: 399
Likes: 0
From: Junction City, Kansas
New code problem I just finished replacing the flywheel, clutch, cylinders, and bleeding the system. I took the car out for a spin and have three new codes that just popped up.
P0102 - mass airflow circuit failure
P0801 - Reverse inhibit control circuit malfunction
P0803 - 1-4 skip shift control circuit
What do all these mean and what is the relationship between them and a clutch replacement?
P0102 - mass airflow circuit failure
P0801 - Reverse inhibit control circuit malfunction
P0803 - 1-4 skip shift control circuit
What do all these mean and what is the relationship between them and a clutch replacement?
My guess
PO102, Your Maf isn't reading the airflow (replace MAF, check connections and wires) nothing to do with the clutch install, just an unhappy coincidence
PO801, you have a solenoid that prevents you from putting it in reverse above a certain speed (5mph IIRC) that isn't functioning.
Make sure the connection is good, and you haven't switched the connector with the CAGS
PO803 CAGS solenoid isn't functioning, again check your connection, and make sure you haven't swithched connectors with the reverse lockout
I'm betting you simply switched the reverse lockout and the CAGS connectors when you finished the trans install (easy to do BTW)
PO102, Your Maf isn't reading the airflow (replace MAF, check connections and wires) nothing to do with the clutch install, just an unhappy coincidence
PO801, you have a solenoid that prevents you from putting it in reverse above a certain speed (5mph IIRC) that isn't functioning.
Make sure the connection is good, and you haven't switched the connector with the CAGS
PO803 CAGS solenoid isn't functioning, again check your connection, and make sure you haven't swithched connectors with the reverse lockout
I'm betting you simply switched the reverse lockout and the CAGS connectors when you finished the trans install (easy to do BTW)
