disengaging problems

Reply Subscribe

Thread Tools

Search this Thread

Oct 20, 2005 | 07:43 PM

Howie White

Thread Starter

Teching In

Joined: Oct 2005

Posts: 2

Likes: 0

disengaging problems

i just bought a dual friction center-force clutch and i have bled and bled my clutch but the clutch still will not disengauge

i have a 2000 ss camaro with the ls1 and 6 speed

Oct 20, 2005 | 08:33 PM

SPEEDYws6

TECH Fanatic

iTrader: (9)

Joined: May 2005

Posts: 1,085

Likes: 0

From: Longview, TX

I'm not too familiar with center force, but you most likely need to shim your slave or get an adjustable master cylinder. Has your flywheel been resufaced?

Oct 20, 2005 | 08:55 PM

Howie White

Thread Starter

Teching In

Joined: Oct 2005

Posts: 2

Likes: 0

where can you get the slave shims at

Oct 20, 2005 | 08:56 PM

Howie White

Thread Starter

Teching In

Joined: Oct 2005

Posts: 2

Likes: 0

btw yes i did resurface the flywheel

Oct 23, 2005 | 03:57 AM

N3V3RL8T

TECH Apprentice

iTrader: (2)

Joined: Sep 2005

Posts: 324

Likes: 0

From: College Station

I need to know where to get some shims too.

Oct 23, 2005 | 07:27 AM

98TADRIVER

11 Second Club

iTrader: (36)

Joined: May 2005

Posts: 1,449

Likes: 0

From: South Jerzy

i had the same problems with my spec about 13k miles later. but she burnt up on me a lil bit. i took the expensive route (new stage 3, new flywheel, new mcleod adjustable master cylinder, and slave) that ran me about 1150 with shipping. but Ill never have to mess with it again!!! and the stage 3 is good for 680 hp, lol. ill never push that much hp. my parts should be in wednesday