Should I shorten my B&M Ripper even more? (no 56k)
08-06-2006, 04:03 PM
#1
TECH Enthusiast
Thread Starter
iTrader: (5)
Join Date: Feb 2006
Location: king of prussia, pa (home) and williamsport, pa (school)
Posts: 527
Likes: 0
Received 0 Likes
on
0 Posts
Should I shorten my B&M Ripper even more? (no 56k) i currently have an older model b&m ripper shifter with detachable shift stick. I have already had it shortened about an inch and then rethreaded at a machine shop. this showed a different stroke in shifting and was definetly noticable. right now the throw is pretty decent and i like it, but i can always go shorter. should i go ahead and remove another inch? or should i leave well enough alone?
Neutral
First gear
Second gear
Neutral
First gear
Second gear
08-06-2006, 11:25 PM
#6
Staging Lane
iTrader: (26)
Join Date: Jul 2005
Location: Northwest Missouri
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
I wouldn't go any shorter. I like the stock Hurst shifter because I have full leverage for speed shifting. The t-56 is too notchy for a short shifter IMO
