Textralia OZ700 install problem
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Jul 2004
Location: Houston
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Textralia OZ700 install problem
I bought an OZ700 billet clutch from ECS. MTI here in Houston is installing it and they are having issues with the splines being very tight. When they put in the throw out bearing alinment tool they say it is very tight which is making it very difficult to get the drive shaft to align. Any ideas?
#3
On The Tree
Thread Starter
iTrader: (1)
Join Date: Jul 2004
Location: Houston
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, I emailed them and Jarrod who is in Houston emailed me and is personally going over to MTI to check on it this Monday. That is the best customer support I have experienced in my 50 young years
#5
Staging Lane
Join Date: Oct 2006
Location: Missouri City, TX
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Hey Tom,
Had the OZ700 installed (w/hardened output shaft) a couple weeks ago with no problems at all. With almost 400 mi. of breakin, the clutch feels great...no chatter at all. Mike@ Icon installed mine and had no problems with the install.
Good luck with the install, they will get it right.
Rob G.
Had the OZ700 installed (w/hardened output shaft) a couple weeks ago with no problems at all. With almost 400 mi. of breakin, the clutch feels great...no chatter at all. Mike@ Icon installed mine and had no problems with the install.
Good luck with the install, they will get it right.
Rob G.