Torque specs for McLeod Clutch install
08-31-2002, 08:43 AM
#1
TECH Fanatic
Thread Starter
Join Date: Dec 2001
Location: Germantown, MD
Posts: 1,220
Likes: 0
Received 0 Likes
on
0 Posts
Torque specs for McLeod Clutch install Hey Guys I as reading through Fireballs clutch install posted over at installuniversity.com. Great step by step there Brian, thanks bro. But near the end it stops giving torque specs for the remaining screws. it says to consult a helms manual. Well unfortunately I don't have one of those. So would any of you guys happen to have the torque specs? I believe the only bolts I have left are the ones that gor from the tranny to the bell housing, the tranny mount, and the drive shaft. Not sure if I missed any but any help would be greatly appreciated.
Mike
p.s. Where do I pick up a helms manual?
Mike
p.s. Where do I pick up a helms manual?
09-01-2002, 10:13 AM
#2
TECH Fanatic
Thread Starter
Join Date: Dec 2001
Location: Germantown, MD
Posts: 1,220
Likes: 0
Received 0 Likes
on
0 Posts
Re: Torque specs for McLeod Clutch install Does anyone know the torque specs for putting the slave cylinder back on the tranny? How about fr the clutch, flywheel, and pressure plate?
Thanks for any help.
Mike
Thanks for any help.
Mike
