cutting the shifter shorter
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Mar 2007
Posts: 669
Likes: 0
From: Land of the Old
cutting the shifter shorter i've got a pro 5 0 I was wondering how much you guys took off of yours.Obviously everyone's preference is diff but I was curious of what everyone else cut off of theirs???
Thanks guys
Thanks guys
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Mar 2007
Posts: 669
Likes: 0
From: Land of the Old
does anyone know what size the shifter is?I took my **** into Home Depot and Ace to find a couple of nuts to put on so i have a something to help keep the cut straight and they were pretty much special ed on the whole situation.
You probably wont find nuts to fit..
not positive...but metric 16mm x 1.5 comes to mind.
Its not hard to cut straight...but it would be nice to have a nut below your cut, so you can back the nut off and de-burr the cut end some.
J.
not positive...but metric 16mm x 1.5 comes to mind.
Its not hard to cut straight...but it would be nice to have a nut below your cut, so you can back the nut off and de-burr the cut end some.
J.
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Mar 2007
Posts: 669
Likes: 0
From: Land of the Old
yea Its 16mm by 1.5 couldnt find any nuts I just used the stopper nut from my shifter ****.Thanks for all of your input i dont have alot of tools or a vice grip for that matter so I wanted to make one cut.haha I had to hold it in one hand and hardcore it with a hacksaw with the other. I ended up taking off 1 1/8inch.I ended up picking the exact thread to cut so when I put my ball on it bottoms out EXACTLY where it needs to be to be lined up.I couldnt believe it.It makes a night and day diff.It seems now i'm shifting quick enough to get wheel hop instead of a chirp.Feels GREAT!!!
thanks again
Cody
thanks again
Cody