I just replaced the slave cylinder and am having some problems. I noticed that when i started to bleed the clutch it wasnt draining at the bleed point rather between the bellhousing and engine.


Someone please tell me that I dont have to tear it all back down.

 

Mine doesnt bleed out of the hole at the bottom of the bellhousing.

I just never payed much attention to it. Maybe that could be a problem.

Bump to figure this out!!

 

found the problem... A nice crack on the inside of the slave cylinder (was on the backside where the inputshaft goes into)

 

Make sure you check your pilot bearing, bellhousing condition, alignment dowels, input shaft end play and input shaft runout just incase the input caused the crack.

 

What if im not losing any fluid though?