Shifter problem
Thread Starter
12 Second Club
iTrader: (21)
Joined: Apr 2006
Posts: 1,406
Likes: 0
From: West Seneca, NY
Shifter problem In the midst of my clutch swap, managed to drop the shifter unit on the concrete floor of the shop. 
When I put it back in, it had a little extra play in the shifter when it's sitting in the neutral position. I can move it in any direction maybe 1/2" - 3/4" while it's sitting in the middle. It still will go back to the middle if you pull it left or right, just not with the authority it used to. Anyone have any clue what I might have fucked up when I dropped it? Maybe knocked one of the springs out of whack? It's a B&M unit.
When I put it back in, it had a little extra play in the shifter when it's sitting in the neutral position. I can move it in any direction maybe 1/2" - 3/4" while it's sitting in the middle. It still will go back to the middle if you pull it left or right, just not with the authority it used to. Anyone have any clue what I might have fucked up when I dropped it? Maybe knocked one of the springs out of whack? It's a B&M unit. Thread Starter
12 Second Club
iTrader: (21)
Joined: Apr 2006
Posts: 1,406
Likes: 0
From: West Seneca, NY
BTW, after checking the floor thoroughly, I couldn't find anything that popped off. I'm going to pull it off the car tonight and check it over really closely, but if anyone has an idea let me know.
