Mandrel Bending Exhaust Shop, near Plainfield or Itasca
#21
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
#24
TECH Resident
iTrader: (3)
Join Date: Mar 2008
Location: Joliet Illinois
Posts: 965
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
it is coming along just waiting on my pushrods probably have them this week...ordered them through my uncle some trends...engine is back in the car too...dyno/tune date is the 15th...
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
#36
TECH Fanatic
iTrader: (23)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
ya I got another trans so that's fine, dropping it off for an ultrabell today or tomorrow. Pat G spec'd me a cam and said it was worth 15rwhp if I milled the heads and ran a thinner gasket so I was looking into getting that done, but I'd have to flycut then. Still be only 11.1:1 after the flycut since I'm running a LQ4 motor. Hopefully it runs alright, guess we'll see.
#37
11 Second Club
iTrader: (14)
Join Date: May 2007
Location: Aurora IL
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
ya I got another trans so that's fine, dropping it off for an ultrabell today or tomorrow. Pat G spec'd me a cam and said it was worth 15rwhp if I milled the heads and ran a thinner gasket so I was looking into getting that done, but I'd have to flycut then. Still be only 11.1:1 after the flycut since I'm running a LQ4 motor. Hopefully it runs alright, guess we'll see.
Nice I Hope the cam and trans works out great for you. We need to get a good group of cars out for a track opening day...