xdanny510x

any one have like dual cut outs on the y pipe or is it a total over kill?
its cause i have a 408 and was thinkin of a new exhaust set up.. i have one on my truck as of now and have a spare in my garage thus thinkin about getting my manderal bent y pipe and putting the cutouts right after the header..

Phantom

iTrader: (16)

That's the way I'm going to do mine next

waterbug1999

iTrader: (3)

I have mine like this on my little ole stock CI motor.



And here is how it sounds with an 11.2 ET run.

http://www.youtube.com/watch?v=PTpSC6ndT5w

blue98Z

iTrader: (29)

nice run. im going to change my exhaust up here very soon and was considering doing this. thanks for the pic. now i know how well it will fit underneath.

waterbug1999

iTrader: (3)

I have the "low pros" they call them... I cant remember what vendor though.

blue98Z

iTrader: (29)

if you happen to remember shoot me a pm if you dont mind

Kingc8r

iTrader: (21)

DMH make the low profile ECOs if I remember correctly

xdanny510x

u got any idle clips?

OIF1VET

iTrader: (54)

Correct. Not listed on his site, you have to call and ask for them. I have a set on my car and love em!!

Cutouts open vid

Kingc8r

iTrader: (21)

Sounds good

OIF1VET

iTrader: (54)

Thanks! Mine are setup the same as Waterbug1999..

jj_z28

iTrader: (14)

Cant really see the other one, but there is 2 haha.

TXCAMSS

iTrader: (60)

I had dual 3" manual cut-outs installed in our 3" Kooks Y-pipe. It made 538rwhp/500rwtq through the open cut-outs in our NA pump gas 408. I don't drive it on the street much anymore so we run dual Borla mufflers off the collectors now. It does make a notice HP gain with them open.

I'll be listing the y-pipe soon since I don't plan on running full exhaust anymore.