Electron Blue Metallic Camaro PHOTOSHOOT!!!
07-30-2009, 05:35 PM
#44
TECH Fanatic
Thread Starter
iTrader: (25)
Join Date: Dec 2005
Location: Denton, Texas
Posts: 1,206
Likes: 0
Received 0 Likes
on
0 Posts
Ya it was highly debated upon but I chose the blue sail panel to be different and it would make spraying ALOT easier... getting in the crack between the sail panel and rear fender is hard enough as is, masking it off would have made things even harder.
07-30-2009, 05:39 PM
#45
TECH Fanatic
Thread Starter
iTrader: (25)
Join Date: Dec 2005
Location: Denton, Texas
Posts: 1,206
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the kind comments everyone! It really helps to know other people think ive done a good job with the car when so much work has been done!
On the back of the bowtie were 2 prongs that I sawed off so they would rest on the billet grille and sit flush against it. Then I used JB Weld on the bottom parting of the prongs so it would stick. Its held up for about 3 years now!
On the back of the bowtie were 2 prongs that I sawed off so they would rest on the billet grille and sit flush against it. Then I used JB Weld on the bottom parting of the prongs so it would stick. Its held up for about 3 years now!
10-22-2010, 04:19 AM
#54
