Newbie that needs help from the Vette's.???
01-30-2011, 11:27 PM
#41
On The Tree
Thread Starter
iTrader: (1)
Join Date: Oct 2010
Location: Dallas Texas
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
OK, so I figured out that it was an oil pressure sensor
. Dont know why the pic failed???? Now what I have is that of a new issue.... I have some heat bleading vents on the heads front & rear. These are the chrome tubes that run a line between the two heads in the front and then travel under the intake manifold to the rear ones. I am just going to block off the ones in the back and run a new line in the front only. Does anyone know where to get these block off plates for the vent lines? Or I might just run them separately... I think the vetts have them running separately and they do not run under the intake manifold. Can anyone tell me???
. Dont know why the pic failed???? Now what I have is that of a new issue.... I have some heat bleading vents on the heads front & rear. These are the chrome tubes that run a line between the two heads in the front and then travel under the intake manifold to the rear ones. I am just going to block off the ones in the back and run a new line in the front only. Does anyone know where to get these block off plates for the vent lines? Or I might just run them separately... I think the vetts have them running separately and they do not run under the intake manifold. Can anyone tell me??? 
