please help ... FJO Controller wiring
Thread Starter
TECH Fanatic
iTrader: (3)
Joined: Mar 2007
Posts: 1,591
Likes: 0
From: Middle east , Kuwait
please help ... FJO Controller wiring Hi fellas , I wanna wire the FJO controller but without the the FPSS that shown in the diagram below , how it goes without the FPSS ? , Also i have AEM Fuel pressure gauge and AEM wideband Air Fuel gauge can i connect one of them on the controller ?
please check Diagram below and let me know
and please check if this is correct or not without FPSS , that i edited check diagram below
please check Diagram below and let me know
and please check if this is correct or not without FPSS , that i edited check diagram below
Last edited by PONTIAC SLP; Feb 10, 2011 at 05:42 PM.
The second one is correct without a FPSS. The first one is for two systems. I believe you just ground pole 85 from the relay (or both if 2 systems) rather than grounding it through a FPSS. The FPSS basically just breaks the grounds to the the solenoids if pressure drops too low. If you want to go without the FPSS, just ground the relay and there wont be anything to interrupt it.
, i'll go with the second diagram . Thread Starter
TECH Fanatic
iTrader: (3)
Joined: Mar 2007
Posts: 1,591
Likes: 0
From: Middle east , Kuwait
