Fastest Nitrous only ls1 F-body
05-28-2011 | 06:47 PM
#21
TECH Addict
Joined: Jan 2002
Posts: 2,950
Likes: 0
From: Magee MS
I dont have 1/4mile times but in the 1/8th, my 99 Trans Am just got done running a 7.206 at 97.38mph with a 1.52 60ft. Prolly not the fastest but I am happy and impressed with it. List of mods:
STOCK: LS1 Long Block (No cam swap, intake, or heads)
STOCK: Throttle Body
STOCK: Rear End and Rear Gearing (3.23s)
STOCK: Torque Arm
150 Single Nozzle Wet shot working through WOT switch and RPM Window Switch
Cheapest Long Tubes We could find
3 Inch Manual Cutouts
SLP Air Lid (Ofcoarse)
EGR and AIR Removal
Built 4L60e with 3200 Stall
M/T Drag Radials
HP Tuners
255 Fuel Pump
NO LIE: This is the mod list. We pulled the RF Tire off the ground with stock wheels and tires on front. I daily drive this car everywhere and I still have A/C. 7.2 1/8th would roughly translate to a 11.2 1/4 if my top end kept pulling hard. I love it. I believe 10.5s are gonna be hard to get without running a 250 shot and better rear end setup.
Oh Yeh... My Trans Am has 135K Miles! Did I mention that?? No. Ok. Yeh there ya go.
STOCK: LS1 Long Block (No cam swap, intake, or heads)
STOCK: Throttle Body
STOCK: Rear End and Rear Gearing (3.23s)
STOCK: Torque Arm
150 Single Nozzle Wet shot working through WOT switch and RPM Window Switch
Cheapest Long Tubes We could find
3 Inch Manual Cutouts
SLP Air Lid (Ofcoarse)
EGR and AIR Removal
Built 4L60e with 3200 Stall
M/T Drag Radials
HP Tuners
255 Fuel Pump
NO LIE: This is the mod list. We pulled the RF Tire off the ground with stock wheels and tires on front. I daily drive this car everywhere and I still have A/C. 7.2 1/8th would roughly translate to a 11.2 1/4 if my top end kept pulling hard. I love it. I believe 10.5s are gonna be hard to get without running a 250 shot and better rear end setup.
Oh Yeh... My Trans Am has 135K Miles! Did I mention that?? No. Ok. Yeh there ya go.
tehehehehe I went 7.3s with the same stuff minus headers, a vig 3600 and a 100 shot spinning to a 1.68 60....
05-31-2011 | 03:55 PM
#22
Teching In
Joined: Oct 2007
Posts: 24
Likes: 0
From: Paducah, Kentucky
05-31-2011 | 09:03 PM
#23
05-31-2011 | 10:47 PM
#24
Teching In
Joined: Oct 2007
Posts: 24
Likes: 0
From: Paducah, Kentucky
06-01-2011 | 09:18 PM
#27
Teching In
Joined: Oct 2007
Posts: 24
Likes: 0
From: Paducah, Kentucky
Basically yes, spraying through shifts. I am not manually shifting. The Window switch is keeping it from spraying if the rpms flare up. The built trans is doing its job and shifting precisely though so... yeah. Its safe.
We are using the fully electronic MSD window switch and we not seen problems with it really.
We are using the fully electronic MSD window switch and we not seen problems with it really.
06-05-2011 | 02:06 PM
#28
http://www.youtube.com/watch?v=B7EWTYVVwpE
Can't give away the exact ET of the car but it's close to where the OP wants to be....it is possible...
Can't give away the exact ET of the car but it's close to where the OP wants to be....it is possible...
09-19-2011 | 07:37 PM
#29
Teching In
Joined: Jun 2010
Posts: 34
Likes: 0
From: Chatom, ALABAMA
New to the site! Whats by far the best heads cam set up for nitrous! Want to go 6.0's 1/8th mile.. If y'all don't mind. Tell me every thing that I need.. I have a 98 ws6 pretty much stock car. Mild cam 4l60e tranny with a 3500 converter and headers and slp exhaust and lid.. Stock rear end and all.. Want to play on the street some as well.. Jus want to get a good opinion from y'all.. Seems like y'all know nitrous.. Thanks for your time fellas
09-20-2011 | 10:23 AM
#31
