nitro daves plate kit/e85
nitro daves plate kit/e85 I have a nitro dave plate kit for an f-body with 78mm plate and the hardlines, it says it can be used up to a 200 shot, but i wanna run e85 through it, how much of a shot can this kit handle running e85
I wouldn't really base your jets based on what the kit says 200hit is. You should start with that as a base and go from there. They jet these kits really rich just as a safety precaution. If you really want to be safe just start will a few sizes bigger on the fuel jet for e85 and adjust accordingly.
You need to get your N/A tune dialed in and then do your nitrous tune and just adjust your fuel jet up as needed using a wideband and datalogger.
You need to get your N/A tune dialed in and then do your nitrous tune and just adjust your fuel jet up as needed using a wideband and datalogger.
Yes i tune with hptuners and i know ill.need a bigger fuel.jet because e85 uses 30% more fueling, but what i need to know is how much of a shot will the solenoids and lines in this kit suplort running e85
Thanks
Thanks
Guest
Posts: n/a
Let me know what shot size's you are looking at and I will give you the jetting.
Cool, i thought the lines and solenoids were only good for up to a 200 shot cause thats the highest jetting the kit comes with, but i was gonna start with a 150 then a 200 and if all is well a 250
My fuel system is a dual walbro system with stock lines and rails, 60# injectors
It should support a 250 shot, i was running 10# of boost with a pt88 a few months ago and my only issue was my 95# injectors ran out
My fuel system is a dual walbro system with stock lines and rails, 60# injectors
It should support a 250 shot, i was running 10# of boost with a pt88 a few months ago and my only issue was my 95# injectors ran out
Guest
Posts: n/a
Cool, i thought the lines and solenoids were only good for up to a 200 shot cause thats the highest jetting the kit comes with, but i was gonna start with a 150 then a 200 and if all is well a 250
My fuel system is a dual walbro system with stock lines and rails, 60# injectors
It should support a 250 shot, i was running 10# of boost with a pt88 a few months ago and my only issue was my 95# injectors ran out
My fuel system is a dual walbro system with stock lines and rails, 60# injectors
It should support a 250 shot, i was running 10# of boost with a pt88 a few months ago and my only issue was my 95# injectors ran out
Best of luck and let that thing eat!
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad GallardoGuest
Posts: n/a
I assume this as well but always best to double check.
