Needed a place to mount my switches, so I pulled out the Sirius radio the previous owner had installed. I bought a 12x12 panel of ABS plastic off Ebay and cut this down to fit. Turned out pretty clean using the besel from the radio.

 

Looks good

 

Mounted the switches this morning, left room for the line lock later.

 

Real nice.

 

Thanks guys I was pretty tickled with out it turned out. Doesn't have the hard edges like some of the panels I've seen. And I did it all for 10 bucks

 

Nice i have my line lock on my b and m ratchet shift so i can usw that instead of foot brake off the line with the stall. I also wired a kill switch thats in my coin tray and my cut out switch wired in there too so know one see it.

 

I did somewhat the same with mine.

 

I almost left if blank and put the switches someplace else because the NGK wideband I'm going to be getting would fit really nice in that spot. Now I'm not sure where I'll mount it. After I delete my HVAC box out of the engine bay I might do something like you did and move them all up to where the ***** are now.

 

Those both look really good