I did somewhat the same with mine. 
Homemade switch panel
Thread Starter
TECH Fanatic
iTrader: (18)
Joined: Jun 2010
Posts: 1,789
Likes: 2
From: Salisbury, NC
Homemade switch panel Needed a place to mount my switches, so I pulled out the Sirius radio the previous owner had installed. I bought a 12x12 panel of ABS plastic off Ebay and cut this down to fit. Turned out pretty clean using the besel from the radio.
TECH Fanatic
Joined: Jan 2012
Posts: 1,076
Likes: 0
Nice i have my line lock on my b and m ratchet shift so i can usw that instead of foot brake off the line with the stall. I also wired a kill switch thats in my coin tray and my cut out switch wired in there too so know one see it.
Trending Topics
Thread Starter
TECH Fanatic
iTrader: (18)
Joined: Jun 2010
Posts: 1,789
Likes: 2
From: Salisbury, NC
I almost left if blank and put the switches someplace else because the NGK wideband I'm going to be getting would fit really nice in that spot. Now I'm not sure where I'll mount it. After I delete my HVAC box out of the engine bay I might do something like you did and move them all up to where the ***** are now.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
